#
# NetWorker
# 7.2.2.Build.422
# LEGATO Software, a division of EMC.
#
# SPECTRA ASC/ASCQ Error Codes
#
0x04, 0x83, door is open, robot disabled
0x3d, 0x80, disconnects must be allowed
0x40, 0xD1, ee door could not be extended
0x40, 0xD2, ee door could not be retracted
0x80, 0x00, generic invalid move
0x80, 0x01, picker not empty
0x80, 0x02, source magazine not available
0x80, 0x03, destination magazine not available
0x80, 0x04, conflict element is reserved
0x80, 0x05, source drive not available
0x80, 0x06, destination drive not available
0x81, 0x00, duplicate scsi address on this bus
0x81, 0x01, move failed drive did not unload or ee door
0x81, 0x04, drive failed to become ready
0x81, 0x18, conflict element is reserved
0x83, 0x01, barcode label is unreadable
0x83, 0x02, problem reading barcode
0x83, 0x03, tape is reserved for front panel
0x84, 0x00, no response from scsi target
0x84, 0x01, check condition from the target
0x85, 0x01, move failed - tape left in jaws
0x85, 0x02, move failed - tape left in source
0x85, 0x03, move failed - picker will reset
0x85, 0x04, long axis motor blocked
0x85, 0x05, gripper motor blocked
0x85, 0x06, rotary motor blocked
0x85, 0x07, medium axis motor blocked
0x85, 0x08, short axis motor blocked
0x85, 0x09, parameter block corrupted
0x85, 0x99, general robotic failure
0x87, 0x00, invalid fprom/invalid id bits
0x87, 0x01, fprom erase operation failed
0x87, 0x02, fprom write operation failed
0x90, 0x00, CAN command timeout
0x90, 0x01, incomplete configuration
0x99, 0x02, invalid CAN command during load
0x99, 0x03, invalid CAN from address during load
0x99, 0x04, invalid CAN seq during load
0x99, 0x05, checksum failure during load
0x99, 0x06, repeated load seq
0x99, 0x07, frame error during load
0x94, 0x08, burn code to flash failed
