#
# NetWorker
# 7.2.2.Build.422
# LEGATO Software, a division of EMC.
#
# ADIC ASC/ASCQ Error Codes
#
0x04, 0x83, aisle power disabled, door could be open
0x04, 0x8d, offline
0x04, 0x90, library needs teaching
0x15, 0x80, robot dropped a cartridge
0x15, 0x81, robot could not pick a cartridge
0x15, 0x82, robot could not put a cartridge
0x24, 0x80, attempt to write a read only buffer
0x26, 0x80, parameter checksum failure
0x29, 0x80, reset for permanent error occurred
0x29, 0x81, reset into degraded mode of operation
0x3b, 0x85, destination of move medium cannot be robot
0x3b, 0x86, source of move medium cannot be robot
0x3b, 0x87, cartridge stuck in drive
0x3b, 0x90, source cartridge loaded and not accessible
0x3b, 0xa0, media types do not match
0x3f, 0x80, could not erase EEPROM
0x3f, 0x84, could not program EEPROM
0x40, 0x80, component (num - 80) failure
0x40, 0x91, gripper error
0x40, 0xa0, accessor could not move vertical (y) axis
0x40, 0xb0, accessor could not move horizontal (x) axis
0x40, 0xb1, accessor could not home horizontal (x) axis
0x40, 0xc0, accessor could not move
0x40, 0xe0, accessor lost power
0x40, 0xe1, excessive temperature
0x53, 0x80, cartridge in ie station not properly loaded
0x53, 0x81, IE station door is open
0x53, 0x82, cannot lock the IE station
0x53, 0x83, cannot unlock the IE station
0x80, 0x01, picker full prior to command
0x83, 0x00, label too short, too long or duplicate
0x83, 0x01, could not read a bar code due to scanner error
0x83, 0x03, cell status and barcode questionable
0x83, 0x04, drive not present
0x84, 0x00, firmware error
